Full Article: PDF
Scientific Object Identifier: http://s-o-i.org/1.1/TAS-02-130-20
DOI: https://dx.doi.org/10.15863/TAS.2024.02.130.20
Language: English
Citation: Chemezov, D., et al. (2024). Modeling and analysis of the aluminum plate drawing process. ISJ Theoretical & Applied Science, 02 (130), 232-235. Soi: http://s-o-i.org/1.1/TAS-02-130-20 Doi: https://dx.doi.org/10.15863/TAS.2024.02.130.20 |
Pages: 232-235
Published: 28.02.2024
Abstract: The analysis of the calculation of the deformed state of a sheet metal blank during its drawing into the die with a rigid punch was performed in the article. It is determined that for the formation of a thin-walled plate, the punch force increases in proportion to the depth of pressing the blank into the die. Constant force indicates the achievement of full contact between the surfaces of the punch and the blank. At the bending points of the blank, maximum deformations are observed, causing a decrease or increase in the part thickness and an increase in the hardening of the material.
Key words: deep drawing, blank, thickness, strain, stress, material.
|
