Full Article: PDF
Scientific Object Identifier: http://s-o-i.org/1.1/TAS-09-125-36
DOI: https://dx.doi.org/10.15863/TAS.2023.09.125.36
Language: English
Citation: Chemezov, D., et al. (2023). The dependence of change in the part thickness on the depth of sheet metal drawing. ISJ Theoretical & Applied Science, 09 (125), 319-321. Soi: http://s-o-i.org/1.1/TAS-09-125-36 Doi: https://dx.doi.org/10.15863/TAS.2023.09.125.36 |
Pages: 319-321
Published: 30.09.2023
Abstract: An analysis of change in the thickness of a hollow part obtained by plastic deformation was carried out in this article. It is noted that when deep drawing sheet metal, the thinning of the part walls can reach up to 12% of the initial thickness. At the same time, the increase in the thickness of the part walls during compression deformation reaches up to 22% of the initial thickness of the sheet metal.
Key words: deep drawing, blank, thickness, thinning.
|
