Information about the scientific conferences and journal
Schedule of conferences
Submit a report to the conference
Requirements to the article
Section
Indexing
Journal archive
Tracing of postal items
The organizing Committee of Conference
Editorial Board
|
|
ISPC Technology and Education, Philadelphia, USA |
|
* Scientific Article * Impact Factor 6.630 |
|
Chemezov D, Bakhmeteva M, Bayakina A, Polushin V, Lukyanova T, Igumentseva A
ANALYSIS OF THE MANUFACTURING PROCESS OF THE CASE-SHAPED CASTING IN THE SAND MOULD. |
|
|
Full Article: PDF
Scientific Object Identifier: http://s-o-i.org/1.1/TAS-06-50-2
DOI: https://dx.doi.org/10.15863/TAS.2017.06.50.2
Language: English
Citation: Chemezov D, Bakhmeteva M, Bayakina A, Polushin V, Lukyanova T, Igumentseva A (2017) ANALYSIS OF THE MANUFACTURING PROCESS OF THE CASE-SHAPED CASTING IN THE SAND MOULD. ISJ Theoretical & Applied Science, 06 (50): 14-52. Soi: http://s-o-i.org/1.1/TAS-06-50-2 Doi: https://dx.doi.org/10.15863/TAS.2017.06.50.2 |
Pages: 14-52
Published: 30.06.2017
Abstract: In the article there are considered the manufacturing stages of the casting of frame of the terminal box in the conditions of JSC «Vladimir electromotive plant». On the basis of the performed computer simulation of the casting process of the casting in the sand mould there were obtained the three-dimensional fields of cooling, the flow velocities and the Niyama criterion for gray cast iron. The time of cooling (solidification) of the alloy in the sand mould was determined. In accordance with the basic technological process of casting in the sand mould, the comparison of the admissible value of volumetric shrinkage of the casting material with the calculated value was performed.
Key words: a casting, melt, a model, time, temperature, filling, solidification, shrinkage, a sand mould.
|
|