Full Article: PDF
Scientific Object Identifier: http://s-o-i.org/1.1/TAS-10-126-1
DOI: https://dx.doi.org/10.15863/TAS.2023.10.126.1
Language: English
Citation: Deryaev, A. R. (2023). The choice of rock cutting tools, the mode of working out and their drive when drilling wells with an electric drill at the goturdepe field. ISJ Theoretical & Applied Science, 10 (126), 1-8. Soi: http://s-o-i.org/1.1/TAS-10-126-1 Doi: https://dx.doi.org/10.15863/TAS.2023.10.126.1 |
Pages: 1-8
Published: 30.10.2023
Abstract: The article discusses the analysis and recommendations on the choice of rock cutting tools, the mode of working and their drive, as well as the technology of drilling vertical and directional wells with an electric drill in the Western part of the oil and gas fields of Turkmenistan in order to increase the mechanical drilling speed and to successfully achieve the design depth. Materials of previously drilled wells, mining and geological characteristics of deposits, as well as operating instructions and rules for the operation of electric drills were used to analyze the selection of rock cutting tools, the working mode and their drive, as well as the technology of drilling vertical and directional wells with an electric drill. This paper provides a detailed analysis of the selection of rock cutting tools, the working mode and their drive, as well as the technology of drilling vertical and directional wells with an electric drill and provides recommendations on not allowing cable section breakdowns during drilling, as well as recommendations on choosing types of drill bits and operating instructions for different types of electric drills. This work can be used to perform the assigned tasks when drilling oil and gas wells with the aim of increasing the mechanical speed.
Key words: electric drilling, flushing units, central hole, bit, drilling mode, rotation speed, axial load, mechanical speed, axial backlash.
|
