Full Article: PDF
Scientific Object Identifier: http://s-o-i.org/1.1/TAS-10-138-20
DOI: https://dx.doi.org/10.15863/TAS.2024.10.138.20
Language: English
Citation: Chemezov, D., et al. (2024). The effect of cutting modes on the quality of treated surface during semi-finish turning of low carbon steel. ISJ Theoretical & Applied Science, 10 (138), 179-183. Soi: http://s-o-i.org/1.1/TAS-10-138-20 Doi: https://dx.doi.org/10.15863/TAS.2024.10.138.20 |
Pages: 179-183
Published: 30.10.2024
Abstract: The analysis of the quality of diametrical surfaces obtained after turning of low carbon steel in various cutting modes is presented in the article. Photographs of the condition of treated surfaces are shown every 5 minutes of the workpiece turning process with a carbide insert without a protective coating.
Key words: surface, turning, quality, cutting modes, carbide insert.
|
