Information about the scientific journal
Submit an article to the journal
Requirements to the article
Section
Indexing
Journal archive
Tracing of postal items
Cooperation
Editorial Board
|
|
Philadelphia, USA |
|
* Scientific Article * Impact Factor 6.630 |
|
Chemezov, D., Petrenko, A., Komissarov, A., & Gorbatenko, O.
Optimization of cutting modes when semifinish and rough milling. |
 |
|
Full Article: PDF
Scientific Object Identifier: http://s-o-i.org/1.1/TAS-08-76-27
DOI: https://dx.doi.org/10.15863/TAS.2019.08.76.27
Language: English
Citation: Chemezov, D., Petrenko, A., Komissarov, A., & Gorbatenko, O. (2019). Optimization of cutting modes when semifinish and rough milling. ISJ Theoretical & Applied Science, 08 (76), 209-213. Soi: http://s-o-i.org/1.1/TAS-08-76-27 Doi: https://dx.doi.org/10.15863/TAS.2019.08.76.27 |
Pages: 209-213
Published: 30.08.2019
Abstract: Results of a multifactor experiment that determine the most optimal milling modes of an aluminium billet are presented in the article. Accuracy of machined surfaces of the aluminium billet was determined by calculated values of roughness. Two-dimensional roughness profiles of the machined flat surfaces at a base length were obtained.
Key words: a surface roughness, an end mill, cutting modes, a billet, a base length.
|
|
