Full Article: PDF
Scientific Object Identifier: http://s-o-i.org/1.1/TAS-11-79-43
DOI: https://dx.doi.org/10.15863/TAS.2019.11.79.43
Language: Russian
Citation: Bogutsky, V. (2019). Definition of parameters readjusting of subsystems of machining modules in production conditions. ISJ Theoretical & Applied Science, 11 (79), 201-208. Soi: http://s-o-i.org/1.1/TAS-11-79-43 Doi: https://dx.doi.org/10.15863/TAS.2019.11.79.43 |
Pages: 201-208
Published: 30.11.2019
Abstract: It has been shown that widespread use, an increase in the technical level and the development of designs of flexible production modules are due to the integrated principle of flexibility of construction and operation embedded in them and correspond to modern market requirements, however, for a more complete and objective assessment of the reliability of the FPM operation, it is necessary to conduct practical studies of the readjustment parameters of the FPM subsystems in production conditions. Reduced statistical data on the results of the study of the periods of time for changeover and the time between applications for the changeover of subsystems FPM: tool, cutting machine and technological equipment, with subsequent calculation of the mathematical expectation and dispersion for each of the changeable elements, their analysis using the Bartlett criterion. Are performed the calculations of the values of the intensity of requests for readjustment and the intensity of readjustment were performed, the ratio between which is one of the indicators characterizing the flexibility of the technological system.
Key words: flexible production module, subsystem, readjusting, statistical data, metal cutting machine, cutting tool, technological equipment.
|
